Barrier Gate Arm Replacement: MAG & ZKTeco

Barrier arm hit by a car? Send us a photo of your barrier gate and its label on WhatsApp. We will match the right arm for your gate, anywhere in Malaysia.

WhatsApp a Photo of Your Gate

Find the Right Arm in 3 Steps

1

Take a photo

Photograph the whole barrier gate and the label or sticker on its cabinet. The label shows the brand and model.

2

Measure the arm

Measure the old arm from the cabinet to the tip. Most arms are 4m, 4.5m, 5m or 6m. See our arm length guide.

3

Check the arm type

Straight, LED, telescopic, folding or fence. Not sure? Just send the photo and we will tell you.

Barrier Arm Types

Arm type What it is Common for
Straight One straight boom Most car park and guardhouse entrances
Straight with LED Straight boom with lights along the arm Entrances used at night, so drivers see the arm clearly
Telescopic Boom in sections that slide into each other Wider lanes, and easier to transport
Folding 90° / 180° Boom with a joint that folds as it opens Basement and indoor car parks with low ceilings
Fence Boom with a hanging fence below Entrances where people or motorcycles should not pass under

Stop the Arm Getting Hit Again

Loop detector

Senses a vehicle over the loop so the arm stays up while a car is underneath.

MAG BRD05 loop detector →

Traffic detector

Extra vehicle detection at the lane, with an LED display.

MAG BRD03 DualRay detector →

Traffic light

Shows drivers when to stop and when to go, so they don’t drive into a closing arm.

MAG TL100 mini traffic light →

Send Us a Photo, We Match the Arm

Condo management, car park operators, factories and guardhouses: WhatsApp a photo of your barrier gate and label, and our team will reply with the right arm.

WhatsApp VSH Technology

VSH Technology Sdn Bhd · Puchong HQ · Sabah branch · 019-348 1168

Scroll to Top